|
|
Post by waynes88gt on Jun 30, 2008 20:41:52 GMT -5
Over the weekend I decided to clean my interior and I had my instrument cluster cover off so I could get to all the crevices and such to clean the dust off. When I removed the hazard/rear defroster switch I must have pulled on the wires too hard and pulled 3 wires out of the connector for the hazard switch. Anyone out there have a diagram that shows which wires go to which location in the connector? Also I broke my drivers door handle, so any pointers on how to change that would be great
Thanks in advance
|
|
|
|
Post by silver91hatch on Jun 30, 2008 21:20:46 GMT -5
Do you have Alldata at work?? If so just look up your year, make and model, go to diagrams, electrical diagrams and search from the, they will give you the pin locations. I'll look at my space harness tomorrow if you can't figure it out. What drivers door handle broke, inside or outside?? Not that hard to do the inside, outside is a little more involved.
|
|
|
|
Post by nova on Jul 1, 2008 0:41:00 GMT -5
ill try and get a decent pic of it tomorrow, or atleast a writeup.
|
|
|
|
Post by Notch93 on Jul 1, 2008 0:59:32 GMT -5
Quick pic I found on the net. I'll pull my switch tomorrow, and get some good pics for you.  |
|
|
|
Post by waynes88gt on Jul 1, 2008 21:01:47 GMT -5
Thanks guys. As far as alldata goes, between that and the hayes manual I have, not much help there. Notch, thanks for the pic, what it did show me helped me put it back together, that and 3 blown 15 amp fuses. As far as the door handle, it is the outer handle, I'll be ordering the parts from FMR as soon as I get my commision check this month.
|
|
