|
|
Post by stangman4lif on Sept 26, 2007 23:33:07 GMT -5
just got a set for ther vert and i cant get the center cap to fit ther front even with the dust cap removed any ideas?
|
|
|
|
Post by silverhemi on Dec 5, 2007 21:58:03 GMT -5
the spindle is too long usually. youd have to cut it and re-drill for the cotter pin. If you dont the wheel will come off. The other think I noticed on another car is that it hits the rotor near on the outside of the bearing race section (raised middle section). You can grind an angle in the outer edge to clearance it for the clips on the cap, if that is the case. For 10 bucks I'd try a spacer first like 92 said. If all else fails, clearance away...
|
|
